Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement .
The trial run is to make sure the accessory
tools are correctly locked in place and will
not became loose during operation .
˜ Working instructions
Working principle:
The oscillating motor allows the accessory
¾
tool to oscillate back and forth 8000 to
20000 times per minute . This allows for
precision in the tightest of spaces .
Sawing/cutting:
Only use undamaged saw blades free from
¾
defects . Bent, dull or otherwise saw blades
can break .
Observe the law and the recommendations
¾
of the material manufacturers when cutting
light construction materials .
Only soft materials such as softwood,
¾
gypsum plasterboard etc . may be processed
using plunge cutting!
Sanding:
Apply even pressure to extend the life of the
¾
sanding sheets .
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack 3 and let the
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product .
¾
The product must always be kept clean, dry
¾
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
¾
safe use and prolong the life of the product .
Clean the product with a dry cloth . Use a
¾
soft brush for areas that are hard to reach .
In particular clean the air vents after every
¾
use with a cloth and soft brush .
The vents must always be clear .
¾
NOTE
Do not use chemical, alkaline, abrasive
u
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces .
˜ Maintenance
The product is maintenance-free .
¾
Before and after each use, check the product
¾
and accessories (e .g . accessory tools) for
wear and damage . If required, exchange
them for new ones as described in this
instruction manual . Observe the technical
requirements (see "Technical data") .
Check covers and safety devices for
¾
damages and correct installation . Replace as
necessary .
GB/IE
37
Advertenties
Hoofdstukken
Inhoudsopgave
