Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inserting open end accessory tools: Place
¾
the accessory tool into the accessory tool
holder 11 .
Inserting close end accessory tools:
Additionally, remove the clamping nut 10 .
Reattach the clamping nut after inserting the
accessory tool .
NOTE
You can attach the accessory tools into
u
the accessory tool holder 11 in any lock-in
position (Fig . H) .
Tightening the accessory tool
(Fig . G)
Push the tool release lever 1 all the way
¾
down .
Removing the accessory tool
(Fig . G)
Fold the insert tool release lever 1 all the
¾
way upwards (180°) .
Removing open end accessory tools: Pull
¾
the accessory tool out of the accessory tool
holder 11 .
Removing close end accessory tools:
Additionally, remove the clamping nut 10 to
remove such accessory tools . Reattach the
clamping nut after pulling out the accessory
tool .
After removing the accessory tool: Push the
¾
tool release lever 1 all the way down .
˜ Setting the oscillation speed
Use the oscillation speed adjustment wheel
¾
4 to set the oscillation speed (Fig . J) .
Setting 1: Low oscillation speed
Setting 6: High oscillation speed
36 GB/IE
NOTE
The oscillation speed required varies by
u
material and working conditions and can
be determined with tests .
The oscillation speed can also be changed
u
during operation .
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product .
m
CAUTION! RISK OF INJURY!
Always hold the product with both hands
u
while working (Fig . I) .
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation .
m
CAUTION! HEALTH RISK!
Never work on materials containing
u
asbestos . Asbestos is considered
carcinogenic .
(Fig . K)
Switching on: Slide the on/off switch 2
¾
forward (ON) .
Switching off: Slide the on/off switch 2
¾
back (OFF) .
Advertenties
Hoofdstukken
Inhoudsopgave
