Download Inhoudsopgave Inhoud Print deze pagina

Preparing The Stove; Assembling The Legs; Smoke Outlet - Dovre 40CB Installatievoorschrift En Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

3.2.

Preparing the stove

Please inspect the stove for damage caused during transport immediately after deliv-
ery and notify your distributor in case there are any defects. Do not put the stove
into operation in the meantime.
In order to avoid damaging the stove during installation and to make handling of the
stove easier, it is recommended to remove previously all loose parts (fire-resistant
bricks, ashtray, ...) from the stove. Note the location of those parts while removing
them, so that you have no difficulties in re-assembling the parts later on.

3.2.1. Assembling the legs

Assemble both parts of the legs at the requested length using the
M6 bolts and rings. Tilt the stove backwards and mount the legs
on the pre-installed M8 bolts on the bottom plate of the stove.

3.2.2. Smoke outlet

Your stove is suitable for three connections: a top, a rear or a side c onnection.
Select the type of connection that you want and break out the equivalent precarved
opening, using the appropriate tool. To do this you have to drill a 10mm hole in the
middle of the cover plate. Place the special tool with the bolt on the inside of the
cover plate en put the washer and the nut on the bolt. Use a ring spanner and turn
the nut until the cover plate breaks out.
Remark: in case of enamelled stove, use a piece of cardboard (20cmx20cm) between
the cover plate and the washer in order
to protect yourself against enamel frag-
ments coming from the part.
Attach the connection collar, which is
supplied with the stove, to the fume
outlet, using the two fastening brac k-
ets on the inside and the nuts on the
outside (see sketch). Make sure that
the brac kets correctly fit into their in-
serts at the left and right hand side of
the ope ning. For rear connection, break
out the precarved plate on the heat
shield. A pre-made opening can always
be closed again using a lid which is
fixed by means of a steel strip and a
bolt (see sketch). Such a lid is available
as spare part.
Seal with stoppe r paint or paste, which
is delivered together with the stove.
23
40CB
03.27899.100

Advertenties

Inhoudsopgave
loading

Inhoudsopgave