Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Connect the video terminal with the video input terminal of TV set (Video, S-Video or
YfCbfCr terminal)
Connect the digital output terminal of this machine (optical or coaxial interface) with the
AC-3 or dts decoder via the optical or coaxial.
Press the "Enter" key on the remote control to enter, then press the "set up" to exit the
function menu, and finish the sel.
Press the Setup key on the remote control to enter (Function menu) .
Press the Enter key on the remote control to confirm, then press the setup key to exit the
function menu, thus the selling is completed.
Press the cursor
the cursor key on the remote control to select the digital output then Press the '-'Enter"
key to the next menu.
Press the cursor
SPDIF/PCM output mode.
Press the "Enter" key on the remote control to enter, then press the "set up' to exit the
function menu, and finish the set.
lnstall the battery into the remote control
Open battery compartment cover of the remote control,as shown by the following diagram.
lnsert two UM-4 or AAA batteries or batteries of same kind and ensure consistence between,
battery polarity and its marking. Close the cover as per the opposite direction of its opening.
Caution:
Don't use any battery as mixed in new/old or with the different brands.
Don't charge the battery or short connect it.
Don't remove the battery or heat and burn it.
key on the remote control to select the Audio Setting, then press
key on the remote control to select the SPDIF/code resource or
Advertenties
Inhoudsopgave
