Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USB Play introduction
Tum on the power, if the compartment tray was not placed disc, the playback source of
USB will be default automatically for the player.
lf the compartment tray was placed disc, The disc as the default playback source. Please
put out the disc, then close the compartment door.
Hang outside Chinese subtitle
Hang outside Chinese subtitle function: intelligence navigation reading disc technic. improving
mechanical lives. Super large storage capacitor ,support mp3/mp4 format. Compatible with six
kinds of Chinese/English Divx soft and hard sUbtitle:*.SRT,*.SMT, ".ASS,".TXT,*.SUB.
Note: This function is relevant to the format of MP3,MP4,JPEG, only the MP3,MP4,JPEG have
their own Chinese title, they have this function.
Intelligence software upgrade
put the upgrade disc into the tray of DVD player, reading the disc automatically,
during upgrade, TV set screen would display upgrade percent.
after upgrade succeed, the tray will automatically open the tray-door,
insert USB with upgrade software into USB port, then upload the software from USB.
Note: During upgrade, Please do not cut off power source. note: no disc state
Electronic anti-vibration
Adopt playback form of storage type, so as player can improve double anti-enterference.
Though when in playback status and interference from out, playing would be yet flow.
OPERATION OF WIRELESS RECEIVER
This unit contains two channels built-in high quality quartz-locked, fixed frequency VHF wireless
receivers precisely matched to the transmitters supplied. After the amplifier has been turned on
by the main power switch, turn microphone volume control clockwise slightly. Extend antenna at
rear side of amplifier fully for best reception. Switch on the wireless microphone and the IR
receiving indicator will light up indicating normal reception.
Note: This unit is supplied with two wireless microphones, (handheld and/or body pack) in two
different frequencies which can be used simultaneously.
OPERATION OF WIRELESS TRANSMITTER
Handheld MIC
Unscrew the battery compartment cover end cap (4) end remove, exposing the
battery compartment. Insert a fresh 9V battery, observing polarity. Re-attach
the battery cover. Turn on the microphone by sliding the power switch (3) to ON
position. The battery LED indicator (2) will light green, indicating full battery
strength. In the case of a low or dead battery, the battery LED will extinguish,
indicating that the battery should be replaced with a fresh one. The IR indicator
in the amplifier should now be it. To preserve battery life, turn the microphone
off when not in use. If you are not going to use the microphone for a long period
of time, take out the battery from microphone to avoid possible battery leakage
to damage the microphone.
Advertenties
Inhoudsopgave
