Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Body Pack Transmitter
Open the battery cover and insert a fresh 9V battery, observing the correct polarity. And then
close the cover. Plug in either the clip-on or the headset microphone supplied. To use the clip-
on MIC, attach it at chest level. Do not place too close to the mouth-a distance of about six
inches usually works best. To use the headset MIC, place it on the head and adjust the MIC
boom so that the MIC is about one inch to the side of the front of the mouth.
(Note: The clip-on or headset MIC wire is also the transmitting antenna. Rolling up or shortening
the wire may during use and keep it as straight as possible.)
Turn on the transmitter by sliding the power switch to ON position. The battery LED indicator will
light red shortly and of a low or dead battery, the battery LED will not light at all, indicating that
the battery should be replaced with a fresh one. The IR indicator on the amplifier should now be
it.
OPERATION OF WIRED MICROPHONE
Connect wired dynamic MIC to MIC in jack and turn on MIC.
NOTE:
Wired, wireless microphone and guitar input volume can be adjusted through microphone
volume control. Adjust echo and bass/treble controls of the amplifier to a comfortable listening
level as desired.
OPERATION OF GUITAR OR OTHER SOUND SOURCE
Connect guitar to guitar input jack or connect other sound source such as CD player to LINE
input jack to amplify the sound.
NOTE:
MP3 and line input volume can be adjusted through MUSIC volume control. Adjust MUSIC
bass, treble controls of the amplifier to a comfortable listening level as desired.
1. MIC in jack
2. Battery LED
3. Power Switch
4. Antenna
5. Headset MIC
6. Clip-on MIC
Advertenties
Inhoudsopgave
