Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
A c c e s s o r i e s
P r e p a r i n g t h e B a s e To o l f o r R i g h t - A n g l e a n d S t r a i g h t S w i v e l H e a d A t t a c h m e n t
•
Disconnect the air supply.
•
Remove any nose assembly items.
•
Remove Stem Collector Bottle Assembly 20 (71213-03800).
•
Replace assembly 20 with Safety Cap (71213-20201).
•
Unscrew Male 'T' Adaptor 1 and remove with 'O' Ring 2, Locknut 3, 'O' Rings 42 and 41, and Seal Housing 5. Do not refit these
items.
•
Screw Stop Nut (71213-20200) onto the front of Head Piston 27 as far as it will go by hand.
•
Fit Jaw Spreader Housing (71210-02101) and 'O' Ring 2, tighten onto Head Piston 27, finally tighten Stop Nut against Jaw
Spreader Housing.
The tool is now ready to be fitted with a swivel head. Instructions page 16.
Item numbers in bold refer to the general assembly drawing and parts list on pages 24-25.
B a s e To o l 7 1 4 0 1
Base tool to receive a nose assembly
1
2
42
41
Base tool to receive a swivel head
71213-20200
STOP NUT
B a s e To o l 7 1 4 0 4
Base tool to receive a nose assembly
1
2
42
41
Base tool to receive a swivel head
71213-20202
STOP NUT
3
5
3
5
27
71213-20102
SAFETY CAP
27
71210-20201
SAFETY CAP
15
Advertenties
Hoofdstukken
Inhoudsopgave
