Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
N o s e A s s e m b l i e s
F i t t i n g I n s t r u c t i o n s
The air supply must be disconnected when fitting or removing nose assemblies.
Item numbers in bold refer to the nose assembly components in all 2 Nose Tip tables on pages 10 and 12.
•
Lightly coat Jaws 4 with Moly Lithium grease*.
•
Drop jaws 4 into Jaw Housing 3.
•
Insert Jaw Spreader 5 into Jaw Housing 3.
•
Locate Buffer 6 on Jaw Spreader 5.
•
Locate Spring 7 onto Jaw Spreader 5.
•
Insert Detent Sleeve 10 into Jaw Spreader Housing 'T' 9. Not applicable to Type 2 Nose Assembly.
•
Fit Locking Ring 8 onto the Jaw Spreader Housing 'T' 9.
•
For tools converted to nose assembly Type 2, fit Locking Ring 8 onto the Jaw Spreader Housing 'T' 9 attached to the tool.
•
Tighten Jaw Housing 3 and assembled components onto Jaw Spreader Housing 'T' 9.
•
Utilising the 'T' section profiles assemble Nose Assembly onto the tool piston via the Male 'T' Adaptor (item 1 pages 24-25).
Not applicable to Type 2 Nose Assembly.
•
Screw the nose tip into Nose Casing 1 and tighten with spanner*.
•
Place Nose Casing 1 over Jaw Housing 3 and screw onto the tool, tightening with spanner*.
S e r v i c i n g I n s t r u c t i o n s
Nose assemblies should be serviced at weekly intervals. You should hold some stock of all internal components of the nose assembly
and nose tips as they will need regular replacement.
Use Spanner 07900-00849 (supplied with tool) to assist when servicing the nose assembly.
•
Remove the nose equipment using the reverse procedure to the 'Fitting Instructions'.
•
Any worn or damaged part should be replaced.
•
Clean and check wear on jaws.
•
Ensure that the jaw spreader is not distorted.
•
Check Spring 7 is not distorted.
•
Assemble according to fitting instructions above.
Item numbers in bold refer to the nose assembly components in all 2 Nose Tip tables on pages 10 and 12.
* Item included in the n G2s service kit. For complete list see page 20.
I M P O R T A N T
9
Advertenties
Hoofdstukken
Inhoudsopgave
