INSTALLATION INSTRUCTIONS FOR INDOOR AND OUTDOOR
UNIT
WARNING: The indoorunit must be connected with the outdoorunit. This operation can only be done by a fully qualified and
certified person or check the regulations applied in your country.
Indoorunit
Do not install in an unstable, sloping location.
•
Do not install the devices in direct sunlight.
•
Do not install in places with flammable material or gas.
•
•
Do not unplug any power cords.
Provide at least 25 cm of free space around the units.
•
Always place the unit higher than the outdoor unit.
•
•
Avoid installing in damp places.
•
Install near the window.
Always install the indoor unit higher than the outdoor unit.
•
Outdoorunit
•
Never install the device in a location where the device can fall.
Make sure you drain with a hose.
•
Install on stable and level ground.
•
Do not place the device in direct sunlight.
•
•
Install the device in places with flammable
material or gas.
Provide free space around the units of
•
at least 25cm
Be considerate of others so as not
•
to cause any noise or other nuisance.
Avoid places with a lot of salt in the air.
•
Installation on the wall
1. Hang the installation in the intended location and choose a strong wall.
2. Mark 4 fixed points on the back of the indoor unit on the wall.
3. Fasten the screws at a distance of at least 4mm ~ max. 9mm from the wall.
4. Now hang the indoor unit on the screws using the 4 fastening points.
Vast gat
24