Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Reversing the door
The side at which the door opens can be
changed from the right side (as supplied) to the
left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver
2. Cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on it's back in
order to gain access to the base, you should rest
it on soft foam packaging or similar material to
avoid damaging the cooling pipes at the rear of
the refrigerator.
1. Open the appliance door and unhinge and remove all
fittings from inside the appliance.
2. Unscrew the 2 screws (10). (Refrigerator with cover
panel)
3. Take off the cover panel (11) and set it down on a soft
surface. (Refrigerator with cover panel)
4. Remove the upper hinge cap (7). (Refrigerator without
cover panel)
5. Remove the two screws blot (6) that connect the upper
hinge (5) on the right side of the cabinet top.
6. Carefully lift the door and place it on a padded surface
to prevent scratching.
7. Remove the plug (9) and transfer it to the uncovered
hole on the right side of the unit. Be sure to press the
button firmly into the hole. (Refrigerator without cover
panel)
8. Remove the two screws (1) that hold the lower hinge (2)
on the right side of the unit.
9. Remove the screw-type leveling front leg (4) and
transfer it to the right side as shown in the adjacent figure.
10. Set the door into it's new place making sure the pin
enters the bushing at the lower frame section (hole).
11. Secure the upper hinge (5) previously removed in step
6 on the left side of the unit. Make sure the pin enters the
bushing on the upper frame section (hole).
12. Loosely secure the lower left hinge (2) and do not
tighten the bolts until the door is in the closed position
and leveled.
13
13. lnsert the plug (9) on the uncovered holes (right side).
(Refrigerator without cover panel)
14. Replace the upper hinge cap (7). (Refrigerator without
cover panel)
15. Turn the appliance upright again.
16. Mount the cover panel (11) at the front and lay it flat on
the rear. (Refrigerator with cover panel)
17. Apply the 2 screws (10) and tighten. (Refrigerator with
cover panel)
18. Open the appliance doors and attach all fittings.
Refrigerator without cover panel
Refrigerator with cover panel
1 Screw
2 Low Hinge
3 Adjustable Low Foot
4 Adjustable High Foot
5 Upper Hinge
6 Screw Bolt
7 Upper Hinge Cap
8 Shaft Sleeve
9 Plug
Screw
⑩
⑪
Cover panel
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
