Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Operation
˜ Switching on/off
Switching on
Switching off
˜ Setting the penetration depth of the engraving
Use the +/– speed control buttons
setting is usually sufficient for the most common applications.
NOTE
u
˜ Changing the engraving tips
m
u
20
GB/IE/NI
1_389435_2201_Short_GB.indd 20
1_389435_2201_Short_GB.indd 20
Never use the product for other purposes and only use original parts/accessories.
Using attachments or accessory tools other than those recommended in the operating
instructions can lead to a risk of injury.
Press and hold the on/off switch
Release the on/off switch
Press the + speed control button
Press the – speed control button
The indication of the LED indicators
adjustment (2 stroke rate levels per LED): At maximum speed, all 3 LEDs
brightly lit. At lowest speed, 1 LED
CAUTION! RISK OF INJURY!
Always switch the product off before carrying out any work on it.
Change the engraving tip
the desired engraving results. Turn the engraving tip lock
[
]
engraving tip lock
can be removed. From below, remove the engraving tip
from the engraving tip lock
Remove the spring and washer.
Slide the washer and spring onto a new engraving tip
product and turn the engraving tip lock
1 ]
[
.
[
1 ]
.
[
4 ]
to set the penetration depth of the engraving. A low
4 ]
[
to increase the penetration depth.
4 ]
[
to decrease the penetration depth.
3 ]
[
are changing according to the speed
3 ]
[
is dimly lit.
[
]
as soon as it becomes worn and no longer delivers
[
]
.
[
]
clockwise to lock the tip in place.
3 ]
[
are
[
]
anticlockwise until the
[
[
]
. Then insert it into the
]
08/08/2022 6:46:36 pm
08/08/2022 6:46:36 pm
Advertenties
Hoofdstukken
Inhoudsopgave
