Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Indicator lamp
A drive command is signalled by illumination of the indicator lamp.
Green: upward travel - Red: stop - Yellow: Downward travel
When the battery starts to lose power, the indicator lamp flashes when trans-
mitting.
The transmission strength and the radio range decrease as battery power de-
clines. The battery must be replaced if the indicator lamp no longer lights up
when a button is pressed.
Programming the transmitter
Before programming this transmitter, a master transmitter
and the limit positions must be programmed.
1) Programming the master transmitter
a) Readying the receiver for programming
Follow the Assembly and Operating Instructions for the re-
ceiver.
• Switch off the receiver power for 5 seconds, then switch it back on.
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in Programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter whilst in Program-
ming mode until the receiver confirms that programming was successful.
The programming process is now complete.
2) Programming additional transmitters
1.
Press the programming button of the master transmitter until the re-
ceiver confirms.
2.
Then press the programming button of the new transmitter until the re-
ceiver confirms.
3.
Now press the programming button of the new transmitter again.
4.
The receiver confirms successful programming.
24 - en
Advertenties
Hoofdstukken
Inhoudsopgave
