Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Emptying the metal container
m
WARNING!
Always switch the product off and
disconnect the power plug
the power supply before performing
inspections, installing accessories or
making adjustments!
m
WARNING!
Empty and clean the product before
u
and after use to avoid the collection of
materials that could pose a fire hazard in
the vacuum cleaner .
Remove the container lid
o
container
(see "Fixing and removing the
[
5 ]
container lid") . Empty the metal container .
˜ Cleaning the pleated filter
Fig . E
1 . Connect the power plug
power supply .
2 . Set the on/off switch
3 . Block airflow through the hose adaptor
Place the hose adaptor on a flat surface .
4 . If the hose adaptor
the crevice nozzle
nozzle from the hose adaptor .
5 . Press and hold the filter cleaning switch
5x for approx . 3 seconds . This blows air
through the pleated filter
NOTE
Clean the pleated filter
u
use to preserve the product's full suction
power .
from
18 ]
[
from the metal
[
13 ]
with a suitable
18 ]
[
to I .
[
16 ]
[
10 ]
is connected to
[
10 ]
: Remove the crevice
7 ]
[
14 ]
[
.
[
19 ]
after each
[
19 ]
˜ Replacing the pleated filter
m
WARNING!
Check the pleated filter
u
damage and deformation . A damaged or
deformed pleated filter cannot be cleaned
and must be replaced . This is necessary
to maintain the functionality of the product
and to protect the product from damage .
Only use replacement filters from Lidl or
u
authorized resellers . Filters that are not
compatible with the product can lead to
injury and product damage .
Removing the pleated filter
Fig . F
1 . Set the on/off switch
2 . Disconnect the power plug
power supply .
3 . Remove the container lid
container
5 ]
[
container lid") .
4 . Turn over the container lid
5 . Hold the pleated filter
pleated filter in an anticlockwise direction .
:
6 . Lift the pleated filter
wire mesh
20 ]
[
7 . Take the pleated filter
mesh
.
[
20 ]
Inserting a new pleated filter
Fig . G
1 . Set the on/off switch
2 . Disconnect the power plug
power supply .
3 . Remove the container lid
container
[
5 ]
container lid") .
4 . Turn over the container lid
one side .
5 . Insert the new pleated filter
mesh
.
[
20 ]
6 . Slide the wire mesh
filter
inside over the filter thread
19 ]
[
regularly for
19 ]
[
to O .
16 ]
[
from the
[
18 ]
from the metal
[
13 ]
(see "Fixing and removing the
.
[
13 ]
by the rim . Turn the
19 ]
[
together with the
[
19 ]
out of the product .
out of the wire
19 ]
[
to O .
[
16 ]
from the
18 ]
[
from the metal
[
13 ]
(see "Fixing and removing the
and put it to
[
13 ]
into the wire
19 ]
[
with the pleated
[
20 ]
22 ]
[
GB/IE/NI
.
13
Advertenties
Hoofdstukken
Inhoudsopgave
