Download Inhoudsopgave Inhoud Print deze pagina

Cleaning And Storage; Before Use; Connecting The Hose - Parkside PAS 1200 F5 Bedienings- En Veiligheidsinstructies

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

The product is equipped with a
 
thermal fuse that automatically
cuts off the power supply if
the product overheats . If this
safety product has turned off
the product, disconnect the
product from the power supply
and let the product cool . Once
the product has cooled down,
you can connect the product
with the power supply and use
the product normally .

Cleaning and storage

m WARNING! Risk of
injury! Disconnect the
product from the power supply
before cleaning work and
when not in use .
Protect the product, its power
 
cord and power plug against
dust, direct sunlight, dripping
and splashing water .
Store the product in a cool,
 
dry place, protected from
moisture and out of the reach
of children .
Protect the product against
 
heat . Do not place the product
close to open flames or heat
sources such as stoves or
heating appliances .
˜ Before first use
m
WARNING!
The product and the packaging are not
u
children's toys! Children must not play with
plastic bags, sheets and small parts! There
is a danger of choking and suffocation!
Unpack all parts and remove all packaging
o
materials .
Make sure the delivery contents are
o
complete and free of damage . If you find
that parts are missing or damaged, do not
use the product and contact your dealer .
Using an incomplete or damaged product
represents a hazard to people and property .
˜ Before use
˜ Connecting the hose
Fig . C
Vacuum cleaning
1 . Align
 
with the notch in the vacuum
11 ]
[
connector 
.
[
4 ]
2 . Push the hose coupler 
vacuum connector 
3 . Turn the hose coupler 
direction until it is fully engaged .
4 . Check if the hose 
8 ]
[
by pulling the hose coupler 
the hose coupler does not move, the hose is
connected properly .
Blowing air
1 . Align
 
with the notch in the blow
11 ]
[
connector
.
[
1 ]
2 . Push the hose coupler 
connector 
.
1 ]
[
3 . Turn the hose coupler 
direction until it is fully engaged and locked
in place .
4 . Check if the hose 
8 ]
[
by pulling the hose coupler 
the hose coupler does not move, the hose is
connected properly .
fully into the
9 ]
[
.
4 ]
[
in a clockwise
9 ]
[
is installed properly
slightly . If
[
9 ]
fully into the blow
[
9 ]
in a clockwise
[
9 ]
is installed properly
slightly . If
9 ]
[
GB/IE/NI
11

Advertenties

Inhoudsopgave
loading

Inhoudsopgave