Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Installation instructions
Ensure that the fitted unit complies with the following
4.
dimensions:
Width
Depth
Height
Preparing the units
Requirement: The unit is suitable for the installation.
→ "Checking the unit", Page 25
Cover the hob to prevent damage.
1.
Ensure that the stability of the fitted unit is guaran-
2.
teed after the cut-outs have been made.
If the cabinet is less than 320 mm deep, remove
3.
part of the back panel.
Create the cut-out for the pipe connection.
4.
If the cabinet base is in place, remove it.
5.
Remove any shavings.
6.
Use the enclosed template to mark the fastening
7.
points on the inside of the cabinet and use a
bradawl to make indentations where the holes are
to be.
Screw in the four enclosed screws for the angle
8.
bracket up to 5 mm.
26
600 mm
Min. 320 mm
Min. 390 mm
Preparing the appliance
Insert the holders for the wall edging strip on the
1.
outside rear of the appliance into the cut-outs and
fold them in to the centre of the unit.
2.
Use the screws provided to secure the handle strip
to the filter pull-out.
Connect the enclosed power cord to the appliance
3.
and secure the stain relief.
Screw the two angle brackets to the appliance. Note
4.
the position of the screws. Screw in the screws until
8 mm of the threaded section is still protruding.
Advertenties
Hoofdstukken
Inhoudsopgave
