Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• All posts show their ID, this may take a few
minutes
NOTICE
An initialization can be done after a
power cycle (switching the power to the product
off and on again).
NOTICE
For settings, service and statistics,
visit the My Yalp section in the Yalp Store.
E.12 Before placing the floor, prepare the ground in
a way that fits your mounting method:
• Add the filling sand to raise the floor to the
indicated dimensions.
• Make sure the ground is even and level in all
directions.
E.13 Water the ground in order to make it stable.
Make sure to be able to walk on the ground without
leaving any marks. The use of a vibratory plate
compactor could be recommended.
F. EXCHANGING PARTS
WARNING Electric shock risk! Disconnecting
cables by pulling them from the middle could cause
product damage and electric shock risks. Only
disconnect cables when the main power switched
EN
EN
off.
NL
BASIC POST HEAD
F.1 Disconnect the main power from the Memo.
DE
F.2 Unscrew the speaker caps and remove them.
F.3 Unscrew the basic post head and lift it.
Disconnect the cable by first twisting and then
pulling it.
F.4 If necessary, remove the memo hat from the
touchscreen unit, by removing the cap hats with a
flat screwdriver and unscrewing it.
F.5 Install the new touchscreen unit:
MASTER POST HEAD
F.6 Disconnect the main power from the Memo.
F.7 Unscrew the front plate and remove it.
F.8 Unscrew the protection plate and remove it.
F.9 Unscrew the master post head and lift it.
Disconnect the cable by first twisting and then
pulling it.
YA3900-210727
E.14 Roll out the 4 parts of the Memo floor. Make
incisions as shown in the image.
E.15 Place the Memo floor on the prepared surface.
Cut the floor to make the Memo posts fit in.
NOTICE
Make sure the cut outs are in the exact
centre of the circles.
E.16 Cut around the edge of the playing field.
E.17 Mix the glue components according to their
instructions.
E.18 Cut the straps to size. Add glue and spread
this evenly. Place the straps on the indicated
locations in order to attach the different parts of
Memo floor together.
E.19 Add the infill sand onto the Memo floor evenly.
Work the sand into the floor using a (rotary) broom.
E.20 Clean up and wait until the glue has hardened
out according to its instructions.
E.21 Let's play the Memo!
• Connect the cable to the touchscreen unit
(push and twist) and screw the unit onto the
basic post
• Screw the memo hat onto the touchscreen unit
and push in the cap hats
• Place the speaker caps and mount them
• Connect the Memo to the power supply
• Initialize the Memo by following the steps from
E.11
F.10 If necessary, remove the memo hat from the
touchscreen unit, by removing the cap hats with a
flat screwdriver and unscrewing it.
F.11 Install the new touchscreen unit:
62
Advertenties
Inhoudsopgave
