Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Programming the transmitter
Before programming the sensor, a master transmitter suit-
able for adjusting sensors must be programmed into the ra-
dio receiver and the limit positions must be programmed.
Up to three sensors can be programmed into the radio re-
ceiver.
Attention
When programming the transmitter, ensure that the range of
travel of the sun protection system is unobstructed, as it may
extend immediately.
1) Programming the master transmitter
a) Putting the receiver into programming mode
Follow the Assembly and Operating Instructions for the re-
ceiver.
• Switch off the power supply to the receiver for 5 seconds, then switch it
back on.
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter while in program-
ming mode until the receiver confirms that programming has been successful.
Programming is now complete.
2) Programming the sensor
1.
Press the programming button on the master transmitter until the re-
ceiver confirms.
2.
Then press the programming button on the sensor until the receiver con-
firms.
3.
Now press the programming button on the sensor again.
4.
The receiver confirms successful programming.
17 - en
Advertenties
Hoofdstukken
Inhoudsopgave
