Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Function
9
iFavor
10
11
12
iFEEL
13
Anti-F
5.3
Operation without remote control
7797829 - v02 - 11052022
Procedure
Save user preferences. User preferences regarding operating mode, fan speed, temperature
setting and fin tilt are saved using this button. Holding the iFavor button pressed for 3 seconds
until the iFavor symbol appears on the remote control display and flashes three times saves
the current settings. Press the button once at any point to revert back to the saved preferen
ces.
Function not available on this product.
Activate night mode. When night mode is active, the
display.
When night mode is activated, the cooling mode automatically increases the set temperature
by 1 °C after 1 hour and another 1 °C after another hour.
During heating mode the set temperature automatically decreases by 2 °C after 1 hour and
another 2 °C after another hour.
Night mode stops automatically after 7 hours, after which the air conditioner stops operating.
Pressing the MODE or ON/OFF button will turn night mode off.
Activate the iFEEL function. When this function is enabled, the remote control display shows
the current room temperature. If it is not activated, the remote control display shows the set
temperature. This function is incompatible with the FAN mode.
Activate the Anti-FUNGUS function. The purpose of this function is to dry the heat exchanger
in the indoor unit, and thus prevent condensation which can cause mould and bad smells.
This function is not factory-set and can be turned on or off as desired.
If the function is activated, the air conditioner should remain off until the function has com
pletely finished.
This function is not activated when the timer is activated or in night mode.
To activate the function, perform the following:
Press the Anti-FUNGUS button while the air conditioner and remote control are set to OFF.
The air conditioner emits two series of five beeps to indicate the function is activated.
The air conditioner stays in this function unless the air conditioner is turned off completely or
the function is manually stopped.
To turn off the function, hold down the Anti-FUNGUS button with the air conditioner and re
mote control set to OFF. The unit will first emit five beeps, then three, indicating that the
function has been disabled.
If you can't use the remote control, you can operate the air conditioner
manually.
5 Operation
symbol will show on the remote control
en
55
Advertenties
Hoofdstukken
Inhoudsopgave
