Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fitting the vent hose
To simplify the installation, there is a choice
of vent outlets: one at the back, the others
in the left and right-hand side. Connect the
hose to whichever is the more convenient
by pulling the ring nut (A) from the vent out-
let at the back, screwing it on to the hose
and pushing it firmly back into place. The
unused vents should now be sealed with
the special snap covers provided.
If the hose is long and the room tempera-
ture low, the moisture might condense to
water inside the hose. This is an unavoida-
ble natural phenomenon. To prevent this
water from Iying in the hose or flowing back
into the tumble dryer, it is advisable to drill a
small hole (via. 3 mm) in the lowest point of
the hose and to place a small container be-
low it. (See picture, point B).
A
A
Once connected to the dryer, run the vent
hose to the desired outlet point, ensuring
that the run's overall length is less than 2
m, and that it contains no more than two
bends. As to the outlet itself, if you have de-
cided on a fixed wall/window grille, a good
local builder's merchant should be able to
supply you with the necessary fittings and
installation advice.
Warning! It is important that exhaust
air must not be discharged into a flue
which is used for exhausting fumes
from appliances burning gas or other
fuels.
Note that to avoid condensation problems,
it is essential that the dryer be fitted with the
flexible hose to carry its "exhaust" at least
beyond the kitchen units; preferable outside
the kitchen. In order to prevent the appli-
ance from overheating, it is important that
21
B
Advertenties
Hoofdstukken
Inhoudsopgave
