Inhoudsopgave
Advertenties
1
Lowering the floor-tool
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered (see fig 33).
Move the Floor-tool lever (see fig.30), to it's lower position (see fig.31).
Note: The machine will still reverse with the Floor-tool in the lowered position, this could possibly damage the
blades. Raise the floor-tool before selecting reverse.
2
Lowering the brush deck
Note: If the brush width has not been set, see 'Setting the width adjustment' on page 12 before proceeding.
Fig.32
The control for lowering the brush deck can be found to the rear right of the machine (fig.32).
Lower the brush deck by moving the left hand release lever to the upper position (see fig.33).
18
Fig.30
244033 06/13 (A07)
Fig.31
Fig.33
Advertenties
Inhoudsopgave
