Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Installing the furniture door
If a handle is required, please ensure this is installed in an appropriate
position before the furniture door is installed on the cabinet door.
i.
Fully open door.
ii.
Starting at the corner, pull the gasket away from the door. Continue to pull
the gasket free from the gasket channel.
iii. Upon removal, lay gasket down on a flat surface.
iv. Align the furniture door panel with the cabinet doors. Secure the furniture
door to the appliance door using clamps.
v.
Using a 3 mm drill bit, drill 6 pilot holes into the wood panel 12 mm deep
using the holes in the door frame as a guide.
Note:
It is important to ensure that all drilled holes are drilled to the
correct depth in order to avoid splits in the wood when hardwood
is installed. You must also take care not to drill all the way through
the door.
vi. Locate 6 of the M4x34 mm screws provided with your unit.
vii. Use a screwdriver, place one screw into each of the 6 pilot holes and screw
into the door, Be careful not to over tighten screws. Ensure the screws sit
flush against the bottom of the channel. Remove clamps from door.
Note:
If panel requires additional adjustment after removing clamps,
slightly loosen each screw and adjust panel as necessary. Tighten
screws upon completion.
viii. Starting at the corners, re-install the gasket into the gasket channel in the
frame, by pushing firmly into place. Make sure the gasket is fully seated
into the channel.
14
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
