Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9.6 Frames
The appliances can be fitted with various frames. The frames are adjustable in depth and can be fitted so they are
parallel to the door.
The installation depth of the appliance depends on the selected frame (see Annex 2, fig. 1)!
!Caution
When assembling the frame proceed as follows:
First remove the door before assembling the frame.
Tip!
In-built frame (no frame):
Ø
Remove the 4 pre-assembled bolts/nuts (see Appendix 2, Fig. 14).
Ø
Slide the frame over the stove into the desired position (see Appendix 2, Fig. 15).
Ø
Fasten the 4 bolts and nuts (the bolts on the inside, the nuts on the outside of the appliance)
(see Appendix 2, Fig. 16).
Ø
Fasten the 2 bolts and nuts on top of the appliance (see Appendix 2, Fig. 16).
Other frames:
Ø
Loosen the 4 pre-assembled bolts (see Appendix 2, Fig. 17).
Ø
Slide the frame in the convection casing between the loosened bolts and the bolts still tight in the appliance
(see Appendix 2, Fig. 18).
Ø
Tighten the nuts. The frame is now clamped between the nuts (see Appendix 2, Fig. 19).
9.7 Adjustable feet
The 2 front adjustable feet of the Instyle and Prostyle 500
these adjustable feet there is a hexagonal nut that is adjusted from outside with an open-end spanner. The rear
adjustable feet are accessible after the removal of the vermiculite plates lying on the bottom.
Adjust the front feet before assembling the frame.
Tip!
42
EA
EA
and 550
models are not adjustable from inside. On
I N S T A L LA T I ON M A N U A L
Advertenties
Hoofdstukken
Inhoudsopgave
