Winding The Lower Thread; Inserting The Bobbin - SilverCrest SNM 33 B1 Bedienings- En Veiligheidsinstructies
Verberg thumbnails
Zie ook voor SNM 33 B1:
- Bedienings- en veiligheidsinstructies (72 pagina's) ,
- Bedienings- en veiligheidsinstructies (98 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Getting ready
Winding the lower thread
Inserting the bobbin
1
3
5
A
6
78
GB / IE
2
4
7
Place the spool (m) on the spool pin (14)
and hold it in place with a spool pin cap (r).
- Small spool pin cap for thin threads
- Large spool pin cap for thick threads
Pull the thread from the spool into the
thread guide, and up to the bobbin (2).
Pull the thread from the inside through a
hole of the empty bobbin (g). Place the
spool on the spool holder (13) and then
push to the right into the filling position.
Hold the end of the thread. Press the pedal
(t). Release the pedal (t) after a few turns.
Release the thread and cut as close as
possible to the spool. Press the pedal (t)
again.
Once the spool is full, it rotates more slowly.
Release the pedal (t). Replace the bobbin
(g) into sewing position and remove it.
Note:
If the bobbin winder spindle (13) is in the
winding position, the sewing process is
automatically interrupted. To sew, push
the bobbin winder spindle (13) to the left
(sewing position).
Important:
Turn power switch (19) to off ("O").
A
When inserting or removing the bobbin (g),
the needle must be fully raised.
1. Open the hinged cover.
2. Pull the bobbin case tab (A) and remove
the bobbin case.
3. Hold the bobbin case with one hand.
4. Insert the bobbin (3) so that the thread
runs in a clockwise direction (arrow). (4)
5. Pull the thread into the slit and under the
tension spring.
6. Hold the bobbin case between the index
finger and thumb on the bobbin case tab
(A).
7. Insert it into the shuttle race.
Note :
The method of bringing up the lower
thread is explained on page 80.
Advertenties
Hoofdstukken
Inhoudsopgave
