Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ATTENTION! Improper use of the
device poses a risk of damage to
property!
You should therefore observe the
following safety instruction:
Never press the locking button (F)
when the "Brush & Cut unit" is
running.
Now pull the disk and the brush off
12
the shaft
Now install the disk and the brush in
13
the reverse order.
Ensure that the disk is properly atta-
14
ched to the flange and the fastening
flange in the brush. Screw in and
tighten up the Allen screw that holds
the disk and the brush in place.
The conversion has now been comple-
ted.
Put the safety hood back in place as
15
shown (1.) and fix it in place with the
Allen screw (2.). Now place the installed
"Brush & Cut unit" on the drive side of the
motor / gearbox unit (G), as shown in the
illustration. Assembly is carried out in
reverse order (
), or as described in
point "5".
After maintenance or cleaning ensure
that all screws, bolts, nuts and safety
devices are secure and assembled.
6.1.3 Variation in which the guide
wheel runs on the lawn area
Figure 16
Align the disk (D) of the "Brush & Cut
16
unit" to the edge of the lawn. Continue
as described in section 6.1.1.
7
Maintenance & Cleaning
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or
components can still be very hot and
may cause burns. It is therefore
important to observe the following
safety instruction:
Wear protective gloves during
maintenance and cleaning!
7.1 Cleaning
WARNING! RISK OF DEATH
DUE TO ELECTRIC SHOCK!
Switch off the device and disconnect
the power cord (C) from the power
supply.
If the "Brush & Cut unit" becomes dirty
then dismantle it for thorough cleaning
(see conversion as described in secti-
on 6.1.2). Clean the brush and the disk
(D) in water or with a strong jet of water
and a hard brush. Then dry the disk and
oil it lightly.
If the device is not going to be used
for a longer period of time, such as
over the winter, then remove the disk
(D), clean it and lightly oil it.
Only use original GLORIA spare parts
for repairs.
Repairs must be carried out by a
GLORIA service point.
7.2 Wear of the brushes
NOTE!
If the brush wears down to a diame-
ter of approx. 90 mm, or the disc
wears down to a diameter of approx.
140 mm, it must be replaced.
- Part No. brush Brush & Cut:
728981.0000
- Part No. disc Brush & Cut:
547291.0000
20
Advertenties
Hoofdstukken
Inhoudsopgave
