Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Programming the built-in
radio control to several
radio transmitters
Up to 8 radio transmitters can be
programmed for this built-in
dimmable radio control.
a.) Connect the built-in dimmable radio control
correctly to a regular 230 VAC mains
network, as described in the section above.
b.) Press the button (2), until the LED (1)
flashes red.
c.) Before the LED (1) stops flashing press the
'ON' button on the desired switch channel
on the radio transmitter where the built-in
radio control is to be programmed. The red
LED (1) will light up. The programming
process has been completed successfully.
d.) Repeat these steps for further
radio transmitters.
18
Deleting programmed radio
transmitters at the built-in
radio control
It is possible to delete
programmed channels.
a.) Connect the built-in dimmable radio control
correctly to a regular 230 VAC mains
network, as described in the section above.
b.) Press the button (2), until the LED (1)
flashes red.
c.) Before the LED (1) stops flashing, press for
3 seconds on the 'OFF' button on the switch
channel that you wish to delete and that
the built-in radio control was programmed
to. The LED (1) will go out and the delete
process has been completed successfully.
d.) Repeat these steps for other
radio transmitters.
Advertenties
Inhoudsopgave
