Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
b.) The 'N' connection is the neutral conductor,
the '
' connection is the switched
output/phase/L.
c.) The two outside screw terminals serve as
a connection for the voltage ('N' = neutral
conductor, 'L' = phase).
d.) The built-in dimmable radio control can be
screwed in place using the side mounting
lugs (distance between the holes in the
mounting lugs = 60 mm).
e.) The built-in dimmable radio control can
also be placed directly in a flush-mounted
or surface box. During mounting please
make sure that the switch on the back of
the casing is free and is not accidentally
activated.
f.) The switch on the back of the casing serves
to programme it to a radio transmitter in
the Cuveo system. Therefore, please adhere
to the following sections before closing the
flush-mounted or surface box and putting
the product into operation.
INITIAL OPERATION
Programming the built-in
radio control to a radio
transmitter
a.) Connect the built-in dimmable radio control
correctly to a regular 230 VAC mains
network, as described in the section above.
b.) Press the button (2), until the LED (1)
flashes red.
c.) Before the LED (1) stops flashing press the
'ON' button on the desired switch channel
on the radio transmitter where the built-in
radio control is to be programmed. The red
LED (1) will light up. The programming
process has been completed successfully.
EN
17
Advertenties
Inhoudsopgave
