Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Caution! Make sure the pool vacuum is always facing downwards when it is placed into the
pool. Otherwise it may bend the pole connector and damage it during the process.
2. To remove the pool vacuum from the pool/spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle/pole connector and draining holes inside the handle chamber on the
rear body.
Caution! Make sure the pool vacuum is always facing downwards when it is removed from the
pool. Otherwise, the pole connector may be bent and damage the pool vacuum in the process.
3. Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
Emptying the filter
Warning! Using the pool vacuum without a filter cone in place will void your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cone before and after
each use.
Caution! If the pool vacuum is charging, disconnect the external adaptor from the power source
and detach the pool vacuum from the charger base.
Emptying the filter cone
1. Place the pool vacuum on a stable surface.
2. Turn the locking knob (on each side) anticlockwise until it is pointing towards the green
marking to unlock and release the transparent canister. Remove the transparent canister
from the rear body.
3. Tilt the transparent case and make sure the smaller end is
pointing upwards, then pull out the filter cone from the
transparent case. Hold the filter cone horizontally and turn its
lid clockwise to detach it from the cone.
Rinse the transparent case and clean out the debris inside
4.
the filter cone. It is recommended to clean the filter cone's
net with splashing water. If brushing is deemed necessary,
use only a soft brush to clean it carefully and gently. DO
NOT apply any pressure to the net.
23
Advertenties
Inhoudsopgave
Probleemoplossen
