Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Getting started
Important! Fully charge the pool vacuum before using it for the first time.
Charging the battery
Warning!
Charging must be done indoors, in a well-ventilated area away from sunlight, children, heat,
-
ignition sources, and with an ambient temperature between 5˚C (41˚F) and 35˚C (95˚F).
Never use the external adaptor and charging base if any damage is detected.
-
Use only the original external adaptor provided.
-
Make sure the pool vacuum and the charging base are clean and dry before set-up.
-
1. Make sure that the pool vacuum is turned off prior to charging.
2. Turn the locking knob (on each side) anticlockwise until it points to the green dot marking
(unlock position) to unlock and release the rear body from the transparent case.
3. Place the rear body (upside down - power on/off button face up) on a flat surface. Align
and slide the hook of the charging base onto the side notch at the bottom of the rear body
until it stops. Make sure their contact plates are properly in contact. Plug the female jack of
the external adaptor into the charging port at the end of the charging base.
Warning!
DO NOT handle the pool vacuum, external adaptor and charging base while it is charging with
-
wet hands and without shoes.
Connect the external adaptor to the power source through a residential current device (RCD).
-
Charge the pool vacuum with the original external adaptor provided.
DO NOT use power extension cords.
-
Fully charge the battery before first use.
-
Charging must be done indoors, in a dry & well-ventilated area away from sunlight, children,
-
heat, ignition sources, and with an ambient temperature between 5˚C (41˚F) and 35˚C (95˚F).
Always disconnect the external adaptor from the power source when charging is complete.
-
Do not leave the pool vacuum in charge for over 20 hours.
-
19
Advertenties
Inhoudsopgave
Probleemoplossen
