Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Immediately turn the power off and disconnect the external adaptor from the power source if
-
you detect any of the following conditions:
•
Offensive or unusual odor
•
Excessive heat
•
Deformation, cracks, leaks
•
Smoke
4. Connect the external adaptor to the power source. Once the pool vacuum begins charging,
the indicator light on the external adaptor will turn red. Normally, it takes about 5 – 6 hours
to reach a full charge. The indicator light will turn green when the pool vacuum is almost
fully charged.
Important!
If the motor is generating noise, immediately turn off the device by pressing the ON/OFF button.
-
Otherwise, it could potentially lead to failure of the shaft seals / motor, and the warranty will be
voided as a result
Charge the pool vacuum completely (about 5 – 6 hours) prior to the first use.
-
5. When charging is complete, disconnect the external adaptor from the power source and
unplug the jack from the charging base.
6. Detach the charger base from the pool vacuum.
7. Normally, the pool vacuum can be operated up to 30 minutes on a full charge (charged for
5 – 6 h).
To re-position the transparent case (with the filter cone inside) to the rear
body, make sure the locking knob on both sides is turned to the unlock
position. Align the raised arch on both sides of the transparent case with the
locking knobs and then turn the knob clockwise until it points to the red
marking to secure the assembly.
Attention! The case has one correct position only. The water-draining valve
must be facing the bottom when holding the cleaner horizontally by the
handle.
Important!
The rechargeable lithium-Ion battery is classified as a consumable item. It has a limited life and
-
will gradually lose its capacity to hold a charge. Therefore, running time of the pool vacuum will
gradually reduce through repeated charging and discharging in operation.
Let the pool vacuum rest for 30 to 40 minutes before charging it again.
-
Set-up before use
1. Handle assembly
Insert the handle into the pool vacuum as shown, until the side pin on the handle is secured to
the handle's locking hole on the rear body.
20
Advertenties
Inhoudsopgave
Probleemoplossen
