Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
!Caution
•
9.1.5 Failure
If one or more fans are not working, please check the following:
•
•
•
•
•
Depending on the results of the above-mentioned checks, the adapter, clickson and/or fan(s) must be replaced.
For replacing the fan(s) and the clickson you are referred to section 9.1.4 'Replacing the fan(s) and/or clickson'.
Replacement parts are available through your supplier.
9.2 Smoke control area United Kingdom
In smoke control areas in the United Kingdom the air slide valve may not be closed too far because of emission
laws. A limiting screw is accordingly supplied with all appliances. This is supplied as a kit in the combustion
chamber. This screw is therefore only used in the smoke control areas in the United Kingdom. In other countries
this screw can be disposed of in the appropriate way.
With the installation of an appliance in the United Kingdom:
Ø
Install the screw as shown in Appendix 2, Fig. 7a + 7b. After fitting, the air slide valve cannot be slid further shut
than legally allowed.
9.3 Outside air connection, convection connection and air slide valve
9.3.1 Outside air connection
It is possible to provide the fire with an outside air connection. This outside air connection is optionally available
as an (external air) kit. This kit can be used for a connection either on the bottom or rear of the appliance and is
available through your supplier. First determine if you want a connection on the bottom or rear side.
Proceed as follows with a connection on the bottom (see Appendix 2, Fig. 8a + 8b):
Ø
Fasten the 'pipe opening' with 4 screws to the small housing.
Ø
Remove the 4 screws on the bottom side of the appliance.
Ø
Then bring the small housing with assembled 'pipe opening' against the plate on the bottom of the appliance.
Ø
Re-use the 4 screws to assemble the small housing.
Ø
Connect the flexible hose (Ø 80 mm) to the round 'pipe opening' of the outside air connection.
Ø
Dispose of unused parts in the appropriate way.
Proceed as follows with a connection on the rear (see Appendix 2, Fig. 8c + 8d):
Ø
Use a hammer to break the rectangular plate out of the rear of the appliance.
Ø
Also break out the side baffle in the middle of the external air kit.
Ø
Fasten the 'pipe opening' with 4 screws to the small housing.
Ø
Assemble the large housing on the small housing using 2 screws and set this to the correct length for the relative
appliance.
Ø
Remove the 6 screws on the bottom side of the appliance.
Ø
Then bring the outside air connection against the plate on the bottom of the appliance.
Ø
Re-use the 6 screws to assemble the external air kit.
Ø
Connect the flexible hose (Ø 80 mm) to the round 'pipe opening' of the outside air connection.
38
Only replace the fan and/or clickson with originals, which are available from your supplier.
Make sure the fans are mounted in the same way. This will prevent unwanted vibrations, which could result
in noise nuisance.
is the adapter connected properly;
is there sufficient voltage on the wall socket
check the outgoing voltage of the adapter (6 - 12V direct voltage);
bypass the clickson (temperature switch) and check the operation of the fans (switch in position I);
check the voltage on the fan(s).
Consult the electrical diagram (see appendix 2, fig. 4).
I N S T A L LA T I ON M A N U A L
Advertenties
Hoofdstukken
Inhoudsopgave
