Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fig. 35
Underlay for the lock body
The lock body underlay allows for a more favourable assembly position of the wall cover plates
to be achieved, as these can be mounted in a more stable area of the doorframe / wall as a
result (Fig. 36-38).
Note: to determine the cylinder length required, the underlay thickness of 18 mm must be
added to the existing thickness of the door leaf.
Fig. 36
Fig. 37
54
II. Use
1. Close the bolt on the reinforced door bar lock
until it is in locked position. The door can now
be opened in locked position. In locked
position, the door guard will latch under its own
weight. The door guard must be raised in order
to unlock it.
2. The door guard unit is maintenance free.
Do not use any aggressive or caustic cleaning
agents to clean the surface.
Fig. 38
Mounting plate ASP17 (fig. 39-41)
The ASP17 mounting plate is suitable for the sturdy fixing of lock casings. It is used, in particular,
when the options for anchoring the reinforced door bar lock casings directly and securely to the
subsurface are inadequate.
1. Establish the position of the lock casings and thus of
Fig. 39
4x
6x
the mounting plate in accordance with the relevant
4x
PR fitting instructions. Note: pay attention to
8x
position – angled position of the plugs in relation to
the masonry.
2. For basic fitting, attach the mounting plate with
screws (E) and, if necessary, plugs (G) in the holes (2)
as an option.
3. Also fix the mounting plate with the long-shaft fixing
(C) through the angled holes (3).
2x
4. If the hold is not adequate, the mounting plate can
G
also be anchored with a combination of M8 threaded
2x
6x
rods through the two holes (4) and injection mortar
(not supplied).
Fig. 40
5. As an option, additional longer long-shaft fixings
(C, not supplied) can be used for anchoring through
the central hole (3).
6. Fit cover (A).
7. Provide the lock casings of the reinforced door bar
with appropriate supports and screw in place in the
required position (fix with 2 selftapping screws (D). If
the rebate height is too small, it may be necessary to
use a lock body support.
Fig.
41
3
2
2
4
6
3*
2
5
5
Subject to technical changes.
6
We accept no liability for printing errors and mistakes.
4
2
© ABUS 2020 |
*
2
3
ABUS August Bremicker Söhne KG | D 58292 Wetter | Germany
optio-
Tel.: +49 (0) 23 35 63 40 |
nal
GB
|
55
Advertenties
Inhoudsopgave
