Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fitting without screw-on plates with or without plastic underlays (Fig. 23)
1. Hold the lock case with the defined plastic underlay onto the marked lock case position.
Drill out holes with Ø 20 mm and a depth of 6 mm for unhinged doors and a rebate <
5 mm on the mounting position. Bore through both mounting holes with Ø 10 mm and a
depth of at least 160 mm for the frame dowels. Insert screw into the dowel (fig. 22),
push both into the dowel hole up to the dowel collar and tighten the screw firmly.
If the screws or the dowels cannot find a secure grip, we recommend all-through screw
fittings with PV1820 (Fig. 29) or the use of composite mortar from well-known brands in
connection with a cylinder screw with hexagon socket and low profile head DIN 7984-
M 8 x 120 – 8.8 or longer.
2. Press down the cover onto the lock cases (Fig. 24).
3. Press the cylinder escutcheon firmly onto the door exterior (Fig. 25).
4. The door bar can also be incorporated into the wall instead of fitting the lock case.
In this case, the cover for the hole in the wall PWA2700 (Fig. 26–28) can be used.
Fig. 22
Fig. 24
VII. Operating instructions
1. Close the door initially with the existing closing safety defice. Then activate the
reinforced door bar PR2700 as additional protection using the key. Close the door bar
until the end stop by turning the key once or twice.
2. The PR2700 must be retracted the other way around until the end stop before opening
the door.
3. The reinforced door bar PR2700 is maintenance-free and does not require any
lubricant. Do not use any aggressive or abrasive cleaning products when cleaning the
surfaces.
50
Fig. 23
Fig. 25
VIII. ABUS special accessories
PWA2700
Note: An embrasure breadth of at least 86 cm is required for embedding into the wall on
both sides (doorway 90 cm).
• When using the PWA2700, first remove the plastic plug from the door bar casing (if
necessary lever through the small hole with a screwdriver / Fig. 26).
• Insert the door bar end piece with round bolts and tighten with the screw of accessory
article PWA2700 (Fig. 27).
• Mount the wall strike plate onto the round bolts.
• Lock the door bar onto the wall until the end stop. Mark out the attachment points (1.) of
the wall strike plate. Close back the door bar (Fig. 28).
• Pre-drill the attachment points for the wall strike plate with Ø 6 mm, insert the dowel
and screw (Fig. 28).
• Drill through both of the external mounting holes (2.) with Ø 10 mm, and a depth of at
least 160 mm. Insert the complete dowel with the screw and tighten (Fig. 28).
• Drill out the holes for the connecting bolts (3.) with Ø 14–16 mm, width a depth of 70 mm
(Fig. 28). Press down the plastic cover.
Fig. 26
Fig. 28
2.
1.
3.
3.
2.
1.
1.
2.
Fig. 27
51
GB
Advertenties
Inhoudsopgave
