9.5 Glass pane
•
!Caution
•
Use the supplied pane window cleaner to remove fingerprints/dirt on the glass pane.
!Tip
9.5.1 Disassembly of glass pane in door
To remove the glass pane in the door, please follow the instructions below (see appendix 2, fig. 10):
Ø
Open the door.
Ø
Lift out the door by sliding it upwards and moving it towards you.
Ø
Place the door on a flat surface.
Ø
Remove the nuts from the strips.
Ø
Remove the strips.
Ø
Lift out the glass pane.
•
!Tip
•
When replacing the sealing cord proceed as follows:
Ø
Open the door.
Ø
Remove the cord and the mastic from the recess.
Ø
Apply a new layer of high temperature-resistant mastic in the recess where the cord was.
Ø
Place a new cord in the recess. Do this loosely and do not pull the cord tight.
Ø
Insert both ends of the cord in the special sleeve.
The cord, the sleeve and the mastic are available through your supplier.
Make sure that the sleeve is placed on the underside of the glass pane.
!Caution
9.5.2 Assembly of glass pane in door
Assemble the glass pane in the door according to the steps described in section 9.4.1 'Disassembly of glass pane
in door', only in reverse order.
Assembly of the door is somewhat different.
!Caution
Proceed as follows when assembling the door (see section 2, fig. 10):
Ø
Bring the hole at the top of the hinging part of the door exactly above the upper and lower pin and allow the door
to lower. The pins slide into the upper and lower hole.
Ø
The door is now assembled.
•
!Caution
•
40
Avoid damage when removing/fitting the glass pane.
Avoid/remove fingerprints on the glass pane because these burn in.
When replacing the glass pane always replace the seal in the door (= seal between the glass pane and the
door).
Check the door sealing cord and replace if necessary.
Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
Place the glass pane (including new pane seal) with the logo to the bottom right.
I N S T A L LA T I ON M A N U A L