Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9.2.3 Heat shield (optional)
Using a heat shield will allow you to place the appliance closer to the wall. This 'heat shield kit' consists of two
guard plates and is optionally available through your supplier.
It is only possible to place a heat shield if the flue gas discharge is connected at the top of the appliance.
Caution!
Proceed as follows:
Guard plate attached to the appliance:
Ø
Loosen the 4 pre-mounted bolts at the rear of the appliance by a few turns (see appendix 2, fig. 5).
Ø
Place the plate against the back of the appliance.
Ø
Tighten the 4 bolts.
Guard plate attached to the discharge pipe:
(only applicable in case of a single wall pipe)
Ø
Allow the guard plate to rest on the appliance at the rear of the flue duct.
Ø
Then press the plate against the flue duct.
Ø
Drill 4 holes (Ø 4 mm) and fix the plate using the supplied screws (see appendix 2, fig. 6).
UK
IN S TA L L A TI O N M A N U A L
Advertenties
Hoofdstukken
Inhoudsopgave
