Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4.
Press the MEMORY button to proceed to programming the next track.
5.
Repeat steps 3-4 until you have programmed all the tracks you require in the playlist, up toa maximum of 20 tracks.
Press the ►II PLAY/PAUSE button on the micro system or remote to begin playback in the programmed order.
6.
To cancel the program sequence press the ■ STOP button on the micro system or remote twice.
7.
Follow the below instructions to repeat tracks on a CD.
1.
During playback press the REPEAT button on the remote control to repeat the current track.
2.
Press the REPEAT button again to repeat all tracks on the disc.
3.
To cancel the repeat function press the REPEAT button once more.
Numeric buttons
While listening to a CD a specific track number can be played by pressing the relative digit on the number buttons.
Track 02 Press 2
Track 12 . Press 2 then 10+
Track 22 • Press 2 then 10+ twice
Random playback/ MP3CD
Follow the below instructions to playback all tracks on a CD in a random order.
During playback press the RANDOM button on the remote control to begin random playback.
Press the RANDOM button again to cancel random playback.
Intro playback/ MP3CD
Press the INTRO button during playback to play the first 10 seconds of all tracks on the disc.
NOTE: When using the BT connection, you can listen to audio wirelessly from a BT audio device (For example an MP3 player)
within 10 meters of the Micro System unit.
Make sure you are in BT input mode,
When selected the BT LINK text on the display will flash while the system tries to connect to previously paired devices.
If no devices are found the BT LINK text will continue to flash to indicate it is ready for pairing a new device.
Enable the BT function on your audio device and search fora device labelled
Audizio Tours in the available list
Select and enable pairing for the Audizio Tours device. lf prompted for a password enter 0000
lf pairing is successful the micro system will play a melody and the BT LINK text will stop flashing.
lf the connected device goes out of range, the micro system will attempt to connect for 2 minutes. When the device comes
into range the unit will reconnect again automatically.
To remove a paired device using the micro system, press and hold the UNPAIR/ENTER button on the micro system or press the
UNPAIR button on the remote The BT LINK text will begin flashing again.
Note: If you turn off either device before pairing is complete the process will need to be repeated when powered ON again.
12
Advertenties
Inhoudsopgave
