Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Before switching to the DAB input mode the antenna needs to be extended fully to allow stations to be located during the
initial scan.
When the DAB mode is activated for the first time the unit will perform a scan for available stations. You will see SCANNING..
0 appear on the display until stations are located and then the O will change to the amount of stations found.
When located the first alphanumerical station will begin playback while the other stations are stored.
lf no stations where located during the scan, relocate the unit, extend the antenna fully and read the Performing a DAB
station scan section.
Listening to the stored DAB stations
To listen the DAB stations that have been stored press the [
buttons on the remote control.
Press the UNPAIR/ENTER button on the micro system or ENTER on the remote to switch to the selected station.
Performing a DAB station scan
Should you need to perform a fresh station scan for example you relocate the unit or a new station comes online follow the
below steps.
Ouick scan searches all DAB channels .
To activate the quick scan press the SCAN button on the micro system or remote control
To activate the full scan press the MENU button on the remote or press and hold the MENU/INFO button on the micro system.
When the FULL SCAN option appears press the ENTER button on the remote or UNPAIR/ENTER on the micro system to perform
a full scan.
Manual DAB tuning
As well as an auto tune function, you can manually tune the receiver. This can help when aligning your aerial or when adding
stations that were missed while auto tuning.
Press the MENU button on the remote or press and hold the MENU/INFO button on the micro system.
When the FULL SCAN option appears press either < TUNE or TUNE > buttons on the remote or [
micro system and locate MANUAL TUNE, press the ENTER button on the remote or UNPAIR/ENTER on the micro system.
Use the < TUNE or TUNE > buttons on the remote or [
multiplexes, which are numbered 174.928 - 239.200MHz.
Now press the ENTER button on the remote or UNPAIR/E NTER on the micro system to enter the selected ensemble/multiplex,
there wilt be a bar graph denoting the signa! strength displayed.
To save any extra stations located to the station list or to return to the default screen, press the ENTER button on the remote
or UNPAIR/ENTER on the micro system.
Pruning DAB stations
When the radio has performed a Scan in several locations you may find there are stored stations that you can no longer
receive . This function automatically removes them from the stored station list
Press the MENU button on the remote or press and hold the MENU/INFO button on the micro system.
When the FULL SCAN option appears press either < TUNE or TUNE > buttons on the remote or [
micro system and locate PRUNE, press the ENTER button on the remote or UNPAIR/ENTER on the micro system.
Use the < TUNE or TUNE > buttons on the remote or [
ENTER button on the remote or UNPAIR /ENTER on the micro system.
DRC (Dynamic range control)
This function causes the radio to reduce the dynamic range of the audio signal. The purpose of this is to adapt the dynamic
range of the audio signal to listening in a noisy environment
Press the MENU button on the remote or press and hold the MENU/INFO button on the micro system.
When the FULL SCAN option appears press either < TUNE or TUNE > buttons on the remote or [
micro system and locate DRC, press the ENTER button on the remote or UNPAIR/ENTER on the micro system.
Use the < TUNE or TUNE > buttons on the remote or [
LOW and DRC HIGH.
Press the ENTER button on the remote or UNPAIR/ENTER on the micro system to save the setting.
Note: This is not available on many DAB stations.
] or [
] buttons on the micro system or < TUNE or TUNE >
] or [
] buttons on the micro system to cycle through the DAB
] or [
] buttons on the micro system to select YES and press the
] or [
] buttons on the micro system to select between DRC OFF, DRC
10
] or [
] buttons on the
] or [
] buttons on the
] or [
] buttons on the
Advertenties
Inhoudsopgave
