Advertenties
Beschikbare talen
Beschikbare talen
De lijm is eenvoudig afwasbaar met veel water.
This vacuum pump set works on 12 volts and is suitable to connect to one
-
This appliance is suitable for use on a construction site, but only in
combination with the correct connection carried out as described. The suction
cup must be checked in accordance with the latest safety requirements which
suits this system.
-
The installation is equipped with a tank. This tank provides at least 20 minutes
of vacuum in the event of a power failure, see the test below for verification.
-
The power must not be switched off during operation.
-
An acoustic signal is provided, this warns when the vacuum is too low. Do not
hoist during the signal.
-
Always ensure that you are within sight and hearing distance from the device.
-
Always use vacuum hoses that are thick-walled so that it can not kink and is
properly checked for leaks. The length must not be longer than 1m, with
secured couplings.
-
There must not be a large distance between the pump set and suction plate
(ground or at most first floor), where both the pump set and the suction plate
are visible for the user.
hose.
-
Ensure that the hose can not snag and/or nothing driver over the hose.
-
We recommend that an annual inspection or maintenance needs to be carried
out by an expert (manufacturer).
-
We strongly emphasize on the following: the people who work with this device
must work in a responsible and safe manner and must be aware of the Health
and Safety Act. The following regulations deserve extra attention: ensure that
no people are or can be present under the load (higher hoisting, larger sales
area) and that safety helmets and further protective equipment are worn.
-
The suction cup is not equipped with CE, only in combination with a suitable
suction cup as described no. 5 becomes a complete machine under the above
CE no.
1. Connect the pump to the suction cup with the hose, see point 1, click 2 times.
2. Connect the suction plate and pump unit to point 2, so that there is 1 complete
device as shown in photo 3.
3. Carry out maintenance according to maintenance instructions before use, see
next paragraph.
4. Switch on the device and wait until the acoustic signal stops. Now the device
is ready for use.
suction cup of various models.
Safety measures
This system must not be used separately with a long
Use:
Advertenties
