Advertenties
Beschikbare talen
Beschikbare talen
5. Place the device against the sheet material with a closed structure, secure the
tap. When the acoustic signal stops, it is ready to lift.
6. You can turn the load, see point 4, You can tilt the load, see point 5. The tilt
point at point 5 must always be secured. When turning and tilting, take all
appropriate measures following the Health & Safety Act, use a tilt angle or
block, this is many times safer and there is less risk of damaging the load.
7. You can also tilt the battery box to the system so that the piston becomes
even more compact and you have less lifting height loss. See photo 6.
1. We recommend to check that the vacuum system is working properly before
use.
2. The test must be carried out as following:
You place the appliance on a glass plate or other sheet material.
-
You switch on the device and wait until the acoustic signal stops and then the
vacuum pump stops. At that moment, the vacuum gauge must indicate at least
-0.7 bar.
-
From this moment on, the vacuum pump may pump "at most" a few seconds
per minute, if this is more frequent or longer lasting than contact the supplier.
-
Allow a small amount of air to escape (partially open) with the loosening valve,
which causes the vacuum gauge to return below -0.6 (the red area). When the
Maintenance
Advertenties
