Advertenties
Beschikbare talen
Beschikbare talen
pointer reaches the red area, the signal must sound, otherwise contact the
supplier.
-
The voltmeter of the device must always be between 10 and 12 when the
pump is running! Load under 10 volts. The device must be "off" during
charging.
-
Regularly check the rubber edges of the suction cup for cracks or wear, repair
if necessary.
-
Clean the rubbers regularly, with the correct cleaning agent. You can use
cleaning vinegar for this, but the supplier can also supply a special cleaner in a
spray bottle.
-
If the device is not switched on, there is a risk that the user can suck with
residual vacuum from the reserve tank. The vacuum gauge will remain in the
red area and you will receive a "no" signal when using an acoustic signal.
Make sure that the device is switched on at all times!
-
Never attempt to repair this device yourself without first consulting the
manufacturer. Never have this device repaired by another company or
maintenance company without first consulting the manufacturer. Only if you
observe the above conditions we can guarantee that you can work pleasantly,
but especially safely with this device for years.
-
If you do not observe the above use and maintenance instructions, we as
manufacturer do not accept any responsibility for any damage that may have
occurred. We are responsible for the device as a manufacturer, it is our task to
deliver it correctly, but as soon as changes are made to the device after
delivery or no proper maintenance is carried out, we can no longer be held
responsible for any resulting defects. damage. In addition, laws, standards and
rules are always adjusted. If you have the maintenance carried out by the
supplier, you also know that your device is always up to date, safe and in
accordance with the latest standards.
-
With this vacuum machine, a vertical tensile test must be carried out at least
once a year with a load of twice the maximum permissible weight, carried out
by an expert.
-
As a user you are responsible for the maintenance and inspection of your own
equipment. You decide who is competent enough to perform the annual
inspection of this hoisting machine. We as a manufacturer are the most expert
to inspect this device. If you do not carry out your annual inspection at the
manufacturer, we as a manufacturer are no longer responsible for the proper
functioning of your machine.
-
The presence of an inspection sticker only says that the device has been
inspected. In the report you will find the findings of the inspector. Therefore,
always read and follow the instructions on the inspection report.
Pay attention:
Advertenties
