Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Troubleshooting
Fault
HomeConnect is not work-
ing correctly.
Information on display panel
Fault
Message showing "D" or "E"
appears in the display.
The temperature display
(freezer compartment)
flashes.
The temperature display
(freezer compartment)
flashes, a warning signal
sounds and
lights up.
Temperature problem
Fault
The temperature differs
greatly from the setting.
34
Cause
Different causes are pos-
sible.
Cause
The electronics have detec-
ted a fault.
The temperature in the
freezer compartment was
too warm.
Different causes are pos-
sible.
The appliance door is open.
The ventilation openings are
covered up.
Larger quantities of fresh
food have been put in.
Cause
Different causes are pos-
sible.
troubleshooting
Go to www.home-connect.com.
▶
troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 38
Press
.
1.
a The temperature display (freezer
compartment) briefly indicates the
warmest temperature reached in
the freezer compartment. The tem-
perature display (freezer compart-
ment) then indicates the set tem-
perature again.
Press
.
2.
a The temperature display (freezer
compartment) no longer flashes.
Press
.
▶
a The alarm is switched off.
Close the appliance door.
▶
Remove any obstructions from in
▶
front of the ventilation openings.
Do not exceed the max. freezing ca-
▶
pacity.
→ "Freezing capacity", Page 27
troubleshooting
Switch off the appliance.
1.
→ Page 18
Switch the appliance back on after
2.
five minutes. → Page 18
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.
Advertenties
Hoofdstukken
Inhoudsopgave
