Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- that the socket that you want to use:
* is earthed;
* gives out the correct voltage (220/240V-50Hz);
* has at least a 13 Amp fuse;
* is secured with a 30 mA earth switch;
* is located in a safe, dry place
When everything is as it should be, you can place the plug in the socket and then
press the switch (I) whereupon the terrace radiator will begin to work.
During the first couple of minutes after connection, two dark dots will be visible on the
surface of the heating elements. This is perfectly normal and does not affect its
operation. When you use the device for the first time (or for the first time in a long
while), you will have to closely observe the device for the first 10 to 15 minutes to be
certain that it is working without any problems.
If you want to turn off the terrace radiator, you should press the switch again to off
(O). When you have brought an end to operation, always remove the plug from the
socket and give the terrace radiator time to cool off before you move or touch it.
Beware! Although the P1500 terrace radiator is splash proof, it should not be used in
the rain or under very humid conditions. Store in a dry place indoors after use, and
do not leave it standing outside at night!
SAFETY DEVICE
The EUROM PD1500 terrace radiator is equipped with a failsafe device, which
switches off the device should it fall, in spite of all safety measures. Should this
happen, immediately remove the plug from the socket and move the switch to 'off'.
Check the terrace radiator closely for damage and have the device sent for
repair/checking by your supplier or a certified electrician. Do not continue to use the
device if you notice any damage!
If you do not notice any damage, you can resume operation with care. Keep a close
eye on the terrace radiator for the first quarter of an hour to check that no
disturbances occur. If they do, immediately disconnect it and contact your supplier or
electrician.
CLEANING & MAINTENANCE
Cleaning
Before cleaning remove the plug from the power outlet and wait until the appliance is
sufficiently cooled off. Wipe the appliance only with a clean and lint-free cloth or a
soft brush. You can use a moist (not wet!) cloth with a rather mild cleaning product.
Ensure that the lamp is fully dry before you return it to operation!
Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
Never use flammable cleaners such as benzene or spiritus. Give the appliance time
to dry before you use it again.
To protect against electrical shock and danger of life, do not immerse cord, plug or
any part of the appliance in water or other liquid. make sure that no moisture
penetrates the heater.
Maintenance
11
Advertenties
Inhoudsopgave
