Preparing The Units; Inserting The Hob Into The Wider Cut-Out; Installing Fixing Rails - NEFF T16BT 6 Series Gebruikershandleiding En Installatie-Instructies
Verberg thumbnails
Zie ook voor T16BT 6 Series:
- Gebruiksaanwijzing (60 pagina's) ,
- Gebruikershandleiding (56 pagina's) ,
- Gebruiksaanwijzing (60 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Installation instructions
18.2 Built-under
Do not install refrigerators, dishwashers, non-ventilated
ovens or washing machines underneath the appliance.
¡ If you fit an oven below the appliance, the worktop
must be at least 20 mm thick, in certain cases even
thicker. Observe the information in the oven installa-
tion instructions.
¡ Make sure that projecting parts such as the mains
housing or the mains cable do not collide, e.g. with
a drawer.
18.4 Preparing the units
The worktop must be level, horizontal and stable.
¡ The fitted units, including wall finishing strips, must
be heat-resistant to at least 90 °C.
¡ Niche cladding within 50 mm of the back wall must
not be combustible (e.g. tiles, stone).
18.5 Inserting the hob into the wider cut-out
1.
Create the wooden battens in accordance with the
drawing.
2.
Check and adjust the cut-out dimensions.
18.6 Installing fixing rails
For stone work surfaces, bond the fixing rails in place.
46
18.3 Intermediate floor
If the underside of the hob can be touched, an interme-
diate floor must be fitted.
¡ Ask your specialist retailer for an intermediate floor
as an accessory.
¡ If you use your own intermediate floor, the minimum
distance to the mains connection of the appliance
must be 10 mm.
¡ Seal the cut surfaces to make them heat-resistant.
This prevents the worktop from swelling as a result
of moisture.
3.
Screw the wooden battens in place so that they are
flush with the upper edge of the worktop. For stone
work surfaces, bond the wooden battens in place.
Advertenties
Hoofdstukken
Inhoudsopgave
