Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MALFUNCTIONS
Fault table
If you are uncertain about whether your appliance is functioning properly, this does not
automatically mean there is a defect. Make sure to check the points mentioned below in the
table first, or visit our website 'www.Etna.nl' for more information.
Problem with the hob
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
first few times the hob is used.
The pans make a noise while
cooking.
You have switched on
a cooking zone, but the display
keeps flashing.
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working and
nothing appears in the display.
A fuse blows as soon as the
hob is switched on.
The
symbol appears in
the display after you have
switched on a cooking zone.
Fault code F00.
Fault code F0 ... F6 and FC.
Error code F7.
Fault code F8 and F08.
Possible cause
The hob is cooling down.
The new appliance is
heating up.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan used is not suitable
for induction cooking.
The preset time has ended.
There is no power supply due
to a defective cable or a faulty
connection.
The appliance is incorrectly
connected.
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
The control panel is dirty or
has water on it.
Defective generator.
The ambient temperature is
not good.
Appliance overheated.
Solution
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
This is normal for certain
saucepans, particularly at
high settings. This does not
harm the pans or the hob.
Use a good pan.
Press any button to switch
off the signal.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
See chapter 'Pans for
induction cooking'.
Clean the control panel.
Contact your service centre.
Switch off all heat sources
in the vicinity of the cooking
plate.
Let the appliance cool down
and then start again.
EN 21
Advertenties
Hoofdstukken
Inhoudsopgave
