Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
JumpArenA
Trampolines
STEP 5
5
Caution: It is wise to wear
leather gloves while attaching
the Springs. Be careful where you
place your hands as the Springs
and frame joints can pinch.
Attach the two blue V-Rings on the
mat and the two middle holes on the
frame by spring (14) there will be 2
springs attached.
Notice: The middle holes are located
14 ft direction
in the center of the two legs on the
14 ft direction.
After the first 2 springs have been
attached to the both mat and frame
, attach the third spring(#3), the
fourth (#4) etc ...... Make sure to
count the holes in the frame and
V-rings of the mat in the appropriate
position.
"B-1"
label
Safety Notice: as you attach
blue V-ring
Springs, carefully count the V-
middle
rings and frame holes. If a V-ring
hole
or a hole is skipped, reattach the
spring in the proper position.
Attach the Springs (14) as follows:
Hook one end of a Spring (14) into a
V-ring sewn on the Jump mat. Hook
a Spring tool (7) shown as the inset
#4
drawing in next to the free end of the
Spring(14 ). Pull it by the spring
14 ft direction
tool(7) until it reaches the frame.
#2
#1
Push the end of the Spring into a hole
in the frame. Unhook the Spring tool.
middle spring
middle spring
#3
Note:The spring has a large hook
which attaches to the frame and a
13
small hook which attaches to the
V-ring
mat ring.
14
7
Frame
17
Advertenties
Inhoudsopgave
