Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
JumpArenA
Trampolines
STEP 3
3
1
Lay Top Tube A-1 (1) and Top Tube
4
B-2 (4) on the ground in the positions
as shown. Make sure the Top Tubes
are turned, so the small holes (spring
holes) are facing the ground.
9
Insert one end of the Top tube B-2
11
(4) with socket into the other Top
10
10
8
10
9
8
tube A-1 (1) with T-joint.
10
The peak of the Leg Brace should
12
12
point toward the ground.
8
8
Insert the Leg Brace(11) into the Leg
extension(12) secure with M6 Bolt(8)
and M6 Washer(10) and M6 Nut(9).
1
4
9
9
Insert the leg halfway into the Socket
of Top Tube B-2 (4) pull out on other
leg and insert into the T-joint of Top
Tube A-1 (1). Press down on both
C
legs at the same time and fully insert
into the socket and T-joint secure
with M6 Bolt (8) and M6 Nut(9).
Repeat step3 additional one time to
assemble one rest
leg sections C.
STEP 4
4
Note: This step requires two
persons
During this step, you will connect the
A
six assembled leg section
C
Large End
B
C
Small End
B
A
16
Advertenties
Inhoudsopgave
