Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Peel off approximately 30 cm of protective film on the back of the LED strip.
• Attach the LED strip to the mounting surface. Ensure that you secure the sensor to a clean surface that is free from
grease, oil, silicon and dirt.
• Repeat this step until the LED strip is fully secure.
• For best results, ensure that the adhesive tape is positioned correctly on your first attempt. It cannot be reused
multiple times.
ATTENTION! Do not bend the LED strip! This may damage the soldered joints.
We recommended that you install a switch to control the mains socket that the power adapter (1) is
connected to. If the mains socket is located far from the LED strip, use an extension cable. These
components are not included with the product.
10. Operation
Connection diagram
2
1
• Insert the connector on the PIR sensor cable into the socket on one of the LED strips. Do the same with the second
LED strip and the second connection cable.
• Insert the two connectors on the Y-cable into the sockets on the PIR sensor cables, and then insert the plug on the
mains adapter (1) into the other end of the Y cable.
1500mm
1500mm
4
3
19
Advertenties
Hoofdstukken
Inhoudsopgave
