Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
8. Preparation for mounting
Read chapter 6 ("Safety instructions") carefully before mounting the product.
• Mount the product so that it is out of the reach of children.
• Only mount the product on a stable surface. For best results, attach the LED strips (2) to a metal surface to ensure
that they can cool down sufficiently.
The product is powered by a 12 V/DC voltage. Never use a higher or alternating voltage.
9. Mounting and connection
Read the information in chapter 8 ("Preparation for mounting") carefully before mounting the product.
a) Securing the PIR sensors
• When mounting the PIR sensor (4), ensure that a mains plug is within a suitable distance so that the connection
cable can reach the power adapter.
• Remove the protective film on one side of the adhesive tape, and then stick the tape to the back of one of the PIR
sensors. Remove the protective film from the other side of the tape.
• Secure the PIR sensor to the mounting surface. Ensure that you secure the sensor to a clean surface that is free
from grease, oil, silicon and dirt.
• For best results, ensure that the adhesive tape is positioned correctly on your first attempt. It cannot be reused
multiple times.
• Repeat the above steps to secure the second sensor.
b) Securing the LED strip
The conductors must not be damaged or interrupted when mounting the LED strip!
When mounting the LED strip on metal surfaces, the mounting surface should be isolated from the
LED strip (2) to prevent short circuits on exposed solder contacts.
Take precautions against electrostatic discharge (ESD) when mounting the product.
• The LED strip can be mounted using the adhesive tape on the rear of the strip. Start by mounting the LED strip at
one end.
18
Advertenties
Hoofdstukken
Inhoudsopgave
