Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Assembly Instructions
Remove all the separate parts from the packaging, lay them
on the floor and check that all are there on the basis of the
packing list in these instructions for assembly and use. Please
note that a number of parts have been connected directly to
the main frame and preassembled.In addition, there are seve-
ral other individual parts that have been attached to separate
units. This will make it easier and quicker for you to assemble
the equipment.
Step 1:
Attach the hand grips (30) at the grip axle (9).
1. Place the hand grips (30) at the grip axle (9) by screwing them
Step 2:
Attach the hand grips (22) at the grip axle (24).
1. Place the front foot (2) into the holder in front of the main fra-
me (1) and screw it tightly by using 2 carriage bolts M8x65 (4),
washers (5), spring washers (6) and cap nuts (7).(
Step 3:
Attach the pedals (10) at main frame (1).
1. Put a washer (9) and a pedal (10) on screw (8) and tighten the
pedals (10) at main frame (1) into appropriate position.
Step 4:
Attach the seat (52) at seat slide (51) and the rear foot (47) at
seat frame (45).
1. Place the seat slide (51) onto the back of seat (52) so that the
holes pattern and screw it tightly by using screw M6x15 (48),
washers (50) and spring washers (49).
2. Put the rear foot (47) into the holder at seat frame (45) and screw
it tightly by using 4 screws M8x16 (46), washers (15) and spring
washers (6).
3. Push the seat frame (45) through the seat slide (51) as showed
in Figure Step 4, so that 4 pulleys can roll onto the top side and 2
pulleys can roll onto the bottom side of seat frame (45).
4. Fix the cushion pad (41) at appropriate position on bottom side
of seat frame (45).
13
Advertenties
Hoofdstukken
Inhoudsopgave
