Inhoudsopgave
Advertenties
PSTx
12.30 Fieldbus AI 9
12.31 Fieldbus AI 10
19.04 Fieldbus failure op.
4.2
Danfoss - Vacon
FC 200
4–10 Motor speed direction
8-01 Control site
8-02 Control source
8-30 Protocol
8-31 Address
8-32 Baud rate
8-33 Parity / Stop bits
8-43 PCD Read
• [02] Configuration
• [03] Configuration
• [04] Configuration
• [05] Configuration
• [06] Configuration
• [07] Configuration
• [08] Configuration
MCD 200 - Met optionele RS 485-uitbreiding.
Tussen de klemmen A1-N2 een kabeljumper aanbrengen.
MCD 500 - Met optionele RS 485-uitbreiding.
Kabeljumpers tussen klem 17-18 en 18-25 toevoegen. Gebruik max. 19200 Baud.
MCD 200, MCD 500
Protocol
Slave ID
Baud rate
Parity
Soft starter
Power factor
Not used
Consider change to "Stop-automatic" for avoiding manual trip
reset in case of intermittent corrupted Modbus messages
Variable speed drive
[2] Both directions
[2] Ctrl. word only
[1] FC port
[2] Modbus RTU
Unique slave ID corresponding to EC 531 setting
Same as EC 531
Same as EC 531
[1612] Motor voltage
[1613] Frequency
[1616] Torque [Nm]
[1617] Speed [RPM]
[1622] Torque %
[1610] Power [kW]
[1614] Motor current
Soft starter
Modbus RTU
Unique slave ID corresponding to EC 531 setting
Same as EC 531. Max 19200 baud.
Same as EC 531
13
nl
Advertenties
Inhoudsopgave
