Advertenties
Beschikbare talen
Beschikbare talen
EN
II. Electric wiring
Connect the power cable to the thermostat and the earth cable on the flange (refer to diagrams
inside the cover).
III. Adjusting the temperature
You can adjust the water temperature in the tank, depending on your hot water needs, either
gradually or in one of the four main levels clearly identified.
This will allow you to use the heating element with greater energy efficiency.
To facilitate adjustment, 4 main levels are marked on the temperature setting button:
Position :
Position : v
Position : ••
This is the recommended setting to prevent burns inadvertently with scalding hot water.
Position : ••• about 85 ° C, very hot water
IV. Specific maintenance conditions
Parts that can be replaced
• Thermostat
• Cover
• Magnesium anode
The seal must be replaced if the heater body is replaced or opened.
Any replacement operation must be performed by a qualified person using
the manufacturer's original parts.
32
Your Water Heater : Electric wiring
protection antifreeze of the water heater (30 ° C max.)
The position does not lead to powering off the heating element.
40 ° C lukewarm water
about 65 ° C, hot water.
• Heater element
• Seal
Advertenties
Hoofdstukken
